ls-is5-操作说明书手册

WARNINGACAUTIONElectrical Shock PreventionFire Prevention1.Do not remove the front cover when input power1.Install the inverter on a non-combustible surface.is applied.Doing so can result in electric shock.Installing the inverter on or near combustiblematerials can result in fire.2.Do not operate the inverter with the front coverremoved.Electric shock can occur due to the2.Disconnect the inverter when the inverter isexposed high voltage terminals and capacitordamaged.Failure to do so could lead to asecondary accident and fire.3.Do not remove the cover except for routineinspections or wiring,even if the input power is3.Do not connect a resistance directly between thenot applied.The capacitor will remain chargedDC terminals P.N.Doing so can result in fire.for a long time even when the power is notapplied.Damage Prevention4.Wiring and routine checkups should beperformed 10 minutes after disconnecting the1.Do not apply voltages higher than the valuesinput power and after checking to see whetherspecified in this manual to the terminals.Doingthe DC voltage is discharged with a tester.so can damage the inverter.(Below DC 30V)2Incorrect terminal connection may damage the5.Do not use a higher grounding method than theinverter.Type 3 grounding method.Incorrectly connecting the polarity (+/-)of the6.Only authorized personnel may perform wiringterminals can damage the inverter.and inspections.4.After disconnecting,the inverter may still be hot.7.Wire the inverter after the inverter installation.Use caution to prevent the possibility of personalinjury.8.Do not operate the switches with wet hands.Doing so may result in electrical shock.9.Electrical shock may occur if the cable insulationis damaged.Insure proper mounting ofequipment to minimize excess stress on powercablesi