Impact-3336-Installation-Guide

Installing the PrinterRibbon Cartridge Installationimpact 33361.Make sure the printer is turned off before inserting the ribbon cartridge.2.Remove the transparent cover part first.And then hold the plastie hooks on bothSerial Dot Matrix Printersides of the sheet holder and pull upwards to remove the transparent sheet holder.After that,move the print head to the middle of the printer.Figure 2If the cartridge is equipped with a ribbon guidance(black plastic part attached to theribbon)jump to step 4.3.The printer might already have a ribbon guidance installed.If that's the case and ifthe cartridge is not equipped with,remove the one installed in front of the print headby pulling it upward,and attaching it to the ribbon as follows:Insert the ribbon as shown in figure 3.Installation GuideFigure 34.Turn the ribbon tension knob according to the direction shown by thearrow on the cartridge.Hold the handle of ribbon cartridge and push theglobaliscartridge gently down.Make sure the plastic hook of ribbon cartridge clickinto the grooves inside the printer as in figure 4.Globalis impact 333625Printer Installation GuideFigure 4Unpacking the Printer5.Install ribbon guidance to the front of print head,and cbeck if the ribbon can slidePacking and Unpacking of the Printerfreely from side to side in the channel between the print head and metal septa.Make sure the following parts are included while unpacking the printer,and no parts aredamaged.Preserve the packing material properly for use in case of future printer transportation.Figure 56.Reinstall the transparent sheet holderFigure IFigure 6Protection Material7.Reinstall the printer transparent cover parts.Insert the fixing chip in theRemove the protection materials before assembling printer:Refer to figure I,front of the printer cover into the fixing groove on the printer and lay it down.and remove the protection materials pointed out by numbers I to 7 on theprinter outside and 8 to 14 inside the printer,and preserve them for the futuretransportation.After removing the protection materials,take out the front paper chute boardfrom the package,and push both hooks gently along the track into both gaplocations of printer.You should hear a"click"when the hook snaps into thegap.Figure 7