Bearcat_101_(Quick_Guide操作说明书手册)

OPERATING INSTRUCTIONSThis receiver is shipped complete with telescoping antenna and programminginstructions allowing full-band,all-band coverage of signals in fair-to-good signal-strength areas.1.With the power cable and antenna properly connected,turn the receiver ON byrotating the "VOLUME"control clockwise.2.Place the 16-channel switches in the up(ON)position.3.Set the "MANUAL-SCAN"switch on "MANUAL."4.Adjust the "SQUELCH"control clockwise until a rushing noise is heard.Thenadjust the "SQUELCH"control counterclockwise until the rushing noisedisappears.5.Press the "MANUAL-SCAN"switch downward and continue to step throughall channels.If the noise should reappear or "break the squelch"on anychannel,adjust the squelch control counterclockwise again slightly,to quietthe receiver.THIS MUST BE DONE BETWEEN STATIONTRANSMISSIONS.6.If your receiver has been programmed to receive your local frequencies,it isnow ready for operation.If not,follow instructions in the ProgrammingSection.7.The "MANUAL-SCAN"switch may now be used to select and monitor anydesired channel.8.To sample all channels automatically,return the "MANUAL-SCAN"switch to"SCAN.Any channel may be omitted as desired by moving the individualchannel switch downward (OFF).PROGRAMMING SECTIONBy simple front panel programming,any frequencies in the bands shown can beselected from the code table and put into the 16 channels in any desired order.Havingdetermined the frequencies you wish to receive,follow the programming instructionslisted below.In step #1 when the "ready"switch is pushed down,the 16 channel switches arechanged from their normal lock-out function to become "data entry"switches.Whenthe "enter"switch is actuated,an automatic cycle begins which erases any previousdata in the memory for that channel and "enters"the new data (or frequency)then setup by the 16 switches.PROGRAMMING INSTRUCTIONSTo program a channel frequency:1.Move "READY"switch to "DOWN"position (Program indicator will light).2.Move all of the 16 lever switches to the down position.