MR-1000RII-_MXA-5000_Manual操作说明书手册

INSTRUCTIONSAIS RECEIVERThank you for purchasing the MXA-5000 AISMXA-5000RECEIVER.Please read these instructions carefully beforeinstallation and operation.PRECAUTIONS.ANEVER apply AC power to the [DC 12 V]connector on.ANEVER touch the receiver with wet hands.This may re-the rear panel.This could cause a fire or damage the re-sult in an electric shock or damage the receiver.ceiver.·△NEVER apply more than25 W RF power or out of.ANEVER connect the receiver to a power source of moreVHF marine frequency (156.000 to 161.450 MHz)to thethan 16 V DC such as a 24 V battery.This will damage the[RADIO]connector on the rear panel.This will damage thereceiver.receiver..ANEVER connect the receiver to a power source usingDO NOT use or place the receiver in areas with tempera-reverse polarity.This will damage the receiver.tures below-20°C(-4F)or above+60°C(+140°月orin.ANEVER cut the DC power cable between the DC plugareas subject to direct sunlight,such as the dashboard.and fuse holder.If an incorrect connection is made afterDO NOT use chemical agents such as benzine or alcoholcutting,the receiver may be damaged.when cleaning,as they can damage the receiver's sur-.ANEVER expose the receiver to rain,snow or any liquids.faces.The receiver may be damaged.Place unit in a secure place to avoid inadvertent use bychildren.FEATURESPANEL DESCRIPTIONSO Dualwatch operation①Power indicatorTwo independent receivers can simultaneously receiveCH87B(161.975 MHz)and CH88B(162.025 MHz).O Power divider bult-inA power divider is built-in the MXA-5000.This provideseasy installation as well,since no extra antenna is②Antenna connectors④Multi connectornecessary-just connect the receiver between your VHFPC DATA OUTmarine transceiver and an antenna⊙3DATA IN-.The internal power divider protects the receiver from a transmitDATA OUT-signal of the VHF marine transceiver.③DC power connectorO GPS receiver is connectableWhen a GPS receiver is connected,the GPS informationis added to the received AlS information,and can be sent1 POWER INDICATORto the connected PC or navigation system.Lights green during power ON.②ANTENNA CONNECTORSO [ANTENNA]SUPPLIED ACCESSORIESConnects to a VHF marine antenna with a PL-259connector①DC power cableO [RADIO]②Angle2Connects to a VHF marine transceiver with a PL-259③Set screws(M3x6mm）….4connector.④Self--tapping screws(M5×20mm).4.VHF marine transceiver:Output power 25 W nominal and⑤Spring washers.4transmit frequency range from 156.000 MHz to 161.4506 Flat washers.4MHz.1 mm =1/32 inchWhen a VHF marine transceiver is connected with anantenna through the MXA-5000,its receive sensitivity(①will be reduced (Insertion loss:approx.3 dB).This isnormal,and does not indicate the receive's malfunction.3 DC POWER CONNECTOR [12V DC]Connects the supplied DC power cable from this con-③⑤⑥nector to an external 12V DC power source.带的7了ff。Da⑨④MULTI CONNECTOR骨孕@@O[PC DATA OUT]Connects to a PC.Icom,Icom Inc.and the loom logo are registered trademarks of loom IncorO[DATA IN]porated (Japan)i