RFSPACE_SDR-IQ_(Guide操作说明书手册)

SDR-IQRFSpAceSDR-IQRFSpAceSDRIQ1.GETTING STARTEDWITH THE SDR-IQ●SpectraVue Software Installation Instructions.SDR-IQ FRONT PANEL1.Do NOT plug in the SDR-IQ uni unil AFTER installing the software.Nothing bad will happen but there will not be any divers available to(1)YELLOW CAPTURE LIGHTo3dun迪r this ne边地pBlinks when the SDR-IQ is capturing RF data and converting itto digital.Pulses when the SDR-IQ is in IDLE mode.2.Run the "SpectraVue SetupXXX.exe"off of the CD or from whereever it has been downloaded ta.(②RED CLIP LIGHT3.Follow the menus and modiy the detaut folder locations as desired.Lit when the composite RF power into the ADC exceeds thefull scale.(It is normal for this light to blink with extreme signal4.Plg n the SDR-IQ USBcable.peaks and some atmospheric pulses.It is recommended touse the builtin attenuators to prevent this from happening to5.A "New Hardware Device"menu should appear and will ask for aoften.This is an indication of an overdrive condtion.)disk ar folderto bad the USB driver from.(3)GREEN POWER LIGHT6.Use "Browse"to find the WSpectraVueSDRIOUSBdriverfolder thatwas created during the software instal process.(For Windows 98Lit when ide and blinks when data is flowing from the SDR-IQusers use the W99USBdriverfolder)to the PC.7.Confinue on with the driver install menu and the new driver shoudbe installed.I using Windows 98,it wil ask for a fidooccat fle.Clickon the "SKIP menuitem and coninue with the nstal.8.Imvoke Spectravue from the Windows "Starf menu or from thedesktop icon if one was creaed during instal.Make sure SDR-Q isANTENNASERIALUSBselected under the input device menu.TO START SPECTRAVUE,HT THE -START F12”BUTTONSDR-IQ REAR PANELGOOD STARTING POINT:(4)ANTENNA CONNECTORMAIN SCREEN-FTA德-2This connects to an antenna or IF output on the back of anexternal radio.Covers 500 Hz to 30 MHz.Smoothing -0FT Size·409g8192VSae-5or 10dB(5)SERIAL CONNECTORSDR-IO Setup-Connects to the serial port of the optional external radio toDEMOD Ok 190KHzhave the SDR-IQ track the frequency.RF Gain -0dB6620 IF Gain -+12 dB(6)SERIAL CONNECTORConnects to a USB 1.0 or USB 2.0 connector on back of PC.2