aqua-troll-800-使用操作说明书手册

In-SituAqua TROLL 800 Quickstart GuideBox Contents1.Instructions12/2.Instrument with sensors and wiper or wiper plug installed3.Hex Wrench4.Screwdriver5.RDO Sensor Cap(if RDO Sensor is included)6.Batteries7.pH/ORP or ISE Sensors (if selected)8.Accessories899.pH maintenance kit(if pH/ORP or ISE sensors are included)Getting StartedInstall the batteries.Unscrew the batteryBend rubber cover back Replace the batterycover to remove it.and insert the batteries.cover.Your Aqua TROLL 800 ships with all sensors installed except for pH/ORP or ISE sensors.If yourinstrument does not include pH/ORP or ISE sensors,all six sensors are installed by the factory.All sensors are factory calibrated and do not need to be recalibrated unless required by site procedures.Install the RDO Cap(RDO sensoronly)Remove the restrictor.Use included hex wrench Use the small hole at theRemove the dust coverto loosen set screw onbottom of the sensor tofrom the RDO sensor.RDO sensor.lever the sensor out.Information subject to change without notice.In-Situ,In-Situ logo,"Water Simplified;VuLink RDO,RuggedCable,TROLL,BaroTROLL HydroVu VuSitu,Baro Merge,and Win-Situare trademarks or registered trademarks of In-Situ Inc2023.Allrights reserved.This product may be covered by patents identified at www.in-situcom/patents2023-06-05|0045802