ASTM-A1016-2024

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT)Committee.Designation:A1016/A1016M-24TERNATIONALStandard Specification forGeneral Requirements for Ferritic Alloy Steel,AusteniticAlloy Steel,and Stainless Steel TubesThis standard is issued under the fixed designation Al016/A1016M:the number immediately following the designation indicates theyear of original adoption or.in the case of revision.the year of last revision.A number in parentheses indicates the year of lastreapproval.A superscript epsilon (indicates an editorial change since the last revision or reapproval.1.Scope*specification and a more stringent requirement of the purchase1.1 This specification covers a group of requirements that,order,the purchase order shall prevail.unless otherwise specified in an individual specification,shall1.3 The values stated in either SI units or inch-pound unitsapply to the ASTM product specifications noted below.are to be regarded separately as standard.Within the text.theTitle of SpecificationASTMSI units are shown in brackets.The values stated in eachDesignationsystem may not be exact equivalents:therefore,each systemshall be used independently of the other.Combining valuesSeamless Carbon-Molybdenum Alloy-Steel Boiler andA209/A209MSuperheater Tubesfrom the two systems may result in non-conformance with theSeamless Ferritic and Austenitic Alloy-Steel Boiler.Superheater.A213/A213Mand Heat-Excharnger Tubesstandard.The inch-pound units shall apply unless the "M"Welded Austenitic Steel Boiler.Superheater,Heat-Exchanger.A249/A249Mdesignation (SI)of the product specification is specified in theand Condenser Tubesorder.Electric-Resistance-Welded Ferritic Alloy-Steel Boiler andA250/A250M1.4 This international standard was developed in accor-Superheater TubesSeamless and Welded Ferritic and Martensitic Stainless SteelA268/A268Mdance with internationally recognized principles on standard-Tubing for General Serviceization established in the Decision on Principles for theSeamless and Welded Austenitic Stainless Steel Tubing forA269/A269MGeneral ServiceDevelopment of International Standards.Guides and Recom-Seamless and Welded Austenitic and Ferritic/AusteniticA270/A270Mmendations issued by the World Trade Organization TechnicalStainless Steel Sanitary TubingBarriers to Trade (TBT)CommitteeSeamless and Welded Carbon and Alloy-Steel Tubes forA334/A334MLow-Temperature Service2.Referenced DocumentsWelded Austenitic Stainless Steel Feedwater Heater TubesAB8R/ASRRMAustenitic Stainless Steel Tubing for Breeder Reactor CoreA771/A771M2.1 ASTM Standards:2ComponentsSeamless and Welded Ferritic/Austenitic Stainless Steel Tubing A789/A789MA209/A209M Specification for Seamless Carbon-for General ServiceMolybdenum Alloy-Steel Bo