CS100_Operating-使用说明书手册uctions

cS100CHARGING SCALE #2010-0000Key FunctionRecovery/RecycleCautionONTurns scale on.1.Remove platform from case.1.Replace 9V battery when the displayOFFTurns scale off.2.Place DOT tank in center of platform.begins to flash.Do not operate with lowTARESubtract the tare weight.3.Connect DOT tank float switch andbattery.UNITSConverts readout tohose to reover open valves.2.Ensure scale is within calibration bykg.lb.or lb-oz4.Press "ON"key then press "TARE"key.using a known weight.*Hold for 3 seconds to5.Begin recovery.3.Remove the tank,zero and re-verifychange the readout 50kg6.When recovery is complete the displaymeasurement at least 2 times during each(110Lbs/10g)or 150kgwill indicate the amount of refrigerantsetup.(330Lbs/20g)that was removed.4.Make certain that charging hoses are not7.Press "OFF"key and close valves.interfering with scale operation.5.Make certain the"TARE"key can not beGeneral Weight MeasurementsCharginginadvertently pressed while tank is being1.Remove platform from casefilled.2.Press"ON"key and select desired units1.Remove platform from case6.The maximum total weight that can safelyby pressing the "Units"key.2.Place DOT tank in center of platformbe placed on this scale according to the3.Press "TARE"key.connect to liquid port.Capacity of Specification is 150kg or4.Carefully place the object to be weighedDisposable tank-place upside down)330Lbs.directly in the CENTER of platform.3.Press "ON"key then press "TARE"key.Any additional weight will permanently5.The gross weight will then be displayed.4.Open the liquid port begin to charge.damage this unit.6.When weighing has been completed,5.When desired amount is met,close valvespress "OFF"key.6.Press "OFF"key.ceHeadquarters:621 Hunt Valley Circle,New Kensington,PA 15068-7074.Phone:1-800-736-4666,Website:"www.bacharach-inc.com"