手册编号206：Icom_IC-F5061_IC-F6061_RMK-3_使用说明书手册

iCOMThank you for purchasing the RMK-3 sEPARATION KIT.The RMK-3 allows you to install the mobile trans-INSTRUCTIONSceiver front panel separately from the main body foradded installation convenience and operation.UseSEPARATION KITeither the optional OPC-607,OPC-608 or OPC-609RMK-3SEPARATION CABLE with the RMK-3.In this instruction,the illustration is described using the IC-F5060 series transceiver.Supplied accessoriesMain body attachmentMounting bracket月at washersMounting screws(M5)M5x12)香香香香T1610Spring washersSelf-tapping screws(M5)M5x16)垂电形形o008Front panel attachmentFlat cableNuts (M5)Bracket screws西西香卷甲甲■SeparationCAUTION!To avoid damage to the transceiver,turn theDisconnect the flat cable OPC-1297A from the front panel.power OFF before separating the front panel from themain body.Flat cableMain bodyThe optional OPC-607 (3 m:9.84 ft),OPC-608(8 m;26.3 ft)orOPC-609*(1.9 m;6.3 ft)SEPARATION CABLE is required for in-stalling the transceiver front panel and main body separately."For Europe version,only the OPC-609 is available.DTurn the transceiver's power OFF,then disconnect the DCFront panelpower cable.2Unscrew the 4 bottom screws.then remove the bottomcover from the transceiver in the direction of the arrow.Flat cable_Front panel5 Unscrew the 4 rear plate screws.then remove the rearplates from both the front panel and main body attach-ments.Bottom cover'This illustrationshows the descrip-3 Remove the front panel from the main body using a stan-tion for the frontdard screw driver as shown below.panel attachment.StandardRear plateUnscrew the cir-screw drivercuit board screw.Main bodyContinue to the back page.Front panellcom,lcom Inc.and the Ycom logo are registered trademarks of Icom Incor-tes,the United Kingdom Germany,France