FURUNOUser's Guide限rHR98oh8疣B减onadREMOTE CONTROL UNIT Model MCU-004a8eRep器Drill hole for 4x16 self-tapping screw (four places)How to install the Remote Control Unit64±1mm2.50)-Screw capncluded itemsNameCode No.Qty(4 pcs)Self-tappingRemote control unit-4x16SUS304000-162-605-10screw (4 pcs)Screw Cap19-032350g-3100404903104Hard Cover19-032-3509-3100-404-913-101Procedure1Using the mounfing template on the left,cut a mountinghole in the installafion site.31mmSet the unit to the hole and secure the unit with four(1.22)self-tapping screws (4x16,supplied).66mmAttach four screw caps (supplied).2.60)Connect the USB connector of the unit to the USB port of eitherthe NavNet TZtouch,TZtouch2 or TZtouch3.Note 1:When using a USB hub to connect this device,keep in mind that the maximum power consumption for thisdevce is 270 mA.Note 2:When you extend the USB cable by 5m or more,a USB hub or USB repeater cable is required.Outline and dimensions26mm54mm#38 mm7.5mm77mmSpecificationsRemote Control Unit MCU-004Ambient temperature-15C to+55CRelafive humidity 93%or less at 40'CDegree of protection IP56 (front),IP22 (back)355*04g±10%Power supplyUSB bus power Consumpioncurent:Max.270 mA)Mass indudes the hard cover and USB cable./USB cableNotes(3m)1.Table shown below indicates tolerance ofdimensions which are not specified.2."#indicates minimum service clearance.3.Use se lf-tapping screws (04x 16,induded)to secure the unit.DIMENS IONS (mm】TOLERANCE (mm】0
请登录后查看评论内容