科朗叉车Crown-SC-5245-40-Troubleshooting-Error-Codes操作与维修手册含电器液压原理图

欢迎访问找舌册网https:/findmanual.cn欢迎访间找手册网W/findmanual.cn/Event CodesEvent CodesMessages after the operator turns the truck ONDisplay Messagesand during operationDuring truck operation,messages can occur that giveDisplayDescriptionvisual aid to the operator.After the operator or servicetechnician corrects the cause of the message,Low Battery,The battery charge is low and theACCESS 1 removes the message.Below is a list ofRekey to Lifttruck does not move.You canthese messages.turn the truck OFF and then ONtwo times.If the battery is notlow,make sure that the FEA-Messages after the operator turns the truck ONTURES Menu F3.4 is set cor-and during operationrectly.Then follow theprocedures for Event Code 315.DisplayDescriptionM1 TempThe temperature of the right trac-BattGateThe battery restraint switchtion motor is too high.Follow the(BRES)is open.Make sure thatprocedures for Event Code 323.the right battery cover is installedM2 TempThe temperature of the left trac-correctly.Make sure that thetion motor is too high.Follow theFEATURES Menu F20.1 is setprocedures for Event Code 338.correctly.Then examine the bat-tery restraint switch(BRES)cir-M3 TempThe temperature of the hydrauliccuit.motor is too high.Follow the pro-cedures for Event Code 228.Cycle BrakeFully push the brake pedal to re-Parameters Modi-lease the brakes.The Access 1 2 3 Menu settingsfiedchanged to the factory defaultFWD/REVThe forward and reverse switchsettings.Follow the proceduresclose at the same time.Followfor Event Code 318.the procedures for Event CodePM DueDo a PM on the truck.If the truck327.is not due for a PM,make sureHCM TempThe temperature of ACCESS 2 isthat the HOURS Menu H9 PMtoo high.Follow the proceduresTIMER is set correctly.for Event Code 226.Rekey Truck andThe truck lost calibration.TurnLift CutThe operator is not in the seatCalibratethe truck OFF and ON and followand pulls the lift handle.If the op-the procedures in the CALIBRA-erator is in the seat,examine theTION Menu.seat switch(SES)circuit.RelAccy1The operator moves the first ac-Low BattThe battery charge is low duringcessory lever when the trucktruck travel.If the battery is notturns ON or before the operatorlow,make sure that the FEA-is in the seat.If the operator didTURES Menu F3.4 is set cor-not move the first accessory le-rectly.Then follow thever,and the truck has DC lift,ex-procedures for Event Code 315.amine the first accessory switch(AXS1)circuit.If the truck has anLow Battery,LiftThe battery charge is low,theLockouttruck does not move and theAC hydraulic system,follow thetruck was tumed OFF and ONprocedures for Event Code 209.two times.If the battery is notlow,make sure that the FEA-TURES Menu F3.4 is set cor-rectly.Then follow theprocedures for Event Code 315.C0wn2010PF25072-1Re4/13M4.8-1152-00104Rev.4/13379