R5010-Benchmark-Rotator-操作说明书手册-rev.11-14

Benchmark月L Specifcations:Set the Rotating Direct ion Press the"Mode"keySpeed:arpm to 4orpmuntil the small red LED under "RPM Mode andTimer:1 sec.tog hours or Continuous"Time Mode:are both not illuminated.Then adjustOperations ManualCapacity:Up to 12 x somlthe direction to "C for Clockwise or "A"for Anti-Dimensions:(woodxch)21x 27 x 32 cm (8.25x10.512.5 in.)Item:R5010 (-E)Vi.oClockwise.For Alternate Direction Mode (designedTiltAngle:Adjustable from oto go*for more intense mixcing)set the direction to aW细ght32kgbs)numeric value of12o,8o,24o°，30o°or36o°(faElectrical:10o to 240VAC,50-6oHzone full rotation).The rotator will then rotate theBenchmark RotatorOperating environment:4C (cold room)to 6oCdesired setting.stop (with some mild agitation)andWarranty:2 yearsrotate in the reverse direct ion,then repeat.Rotating MixerPress the "Start/Stop"knob to begin the rotation.Atthe end of the desired time,the rotator will stopll.Product Set-Up:automatically and an end of cycle alarm will beep.Place the rotator on a clean and stable surface.NOTE:A cycle can be stopped at any time byInstall the desired rotisserie tube holder and set thepressing the"Star/Stop"knob while rotat ing.desired tilt angle (adjusting the black box behind thetube holder up and down by hand).Plug the rockerinto a properly grounded outlet.Check that nothingblocks the rotating motion ofthe tube holder.IV.Careand Maintenance:No routine maintenance is required other than toPress the test-tubes firmly into the arms of the tubekeep the unit clean.Cleaning can be done with aholder rotisserie.damp cloth.Avoid the use of solvents as they maydamage the product housing.NOTE:Three rotisserie tube holders are included48 Posit ion:Fortube diameters of ao.amm(a5/2om)aoPosit ion:For tubediameters of a5-omm(a5ml)a2 Position:For tubediametes of 2935mm (5oml)Service and Contact:In the event that service ortechnical support is requiredplease contact Benchmark by phone at 1-g08-769-5555lll.Product Qperation:or by email at info@benchmarkscientific.com.Set the Speed:Press the "Mode"key until the smallred LED under "RPM Mode"is illuminated.Thenadjust the speed from 1 to 4orpm with the controlknob.Introduction:Benchmark's Rotator is a quiet,medium capacity,Set the Time:Press the "Mode"key until the smallBenchmarkrotator that includes rotisserie tube holders for mostred LED under "Time Mode"is illuminated.ThenScientificcommon laboratory test tubes.With adjustableadjust the time from 1 second up to g hours.NOTE:P.O.Bex 709 Edison,NJ 08817 USAspeed and direction,this instrument is useful for aThe time can also be set to run continuous by settingPh:908-769-5555 EM:infoBenchmarkScientine.comvariety oflaboratory applications.the time to"--“.