T3-Gas-Tester-简明操作说明书手册

CROWCONT3 Gas TesterGas Detection You Can TrustInstructionsTo perform the bump test on a T3 unit you will needBefore start of test,check the Gas Tester for any damagesmle gas.a0.5 litrel/minute (om)fixed flow requlto the gasket,kinks in tubing and the tester is clean from(REGO1),tubing and the T3 Gas Tester.any dirt or debris.Connect the T3 Gas Tester as indicated,ensure the gas1.Clpinlet tube is connected to the white connector and theoutlet tube is connected to the black connector.2.Gasket3.Gas releasevalveREGO1WARNING:Do notpress Gas releasevalve while the testerGASis not in use,thereis a risk that gas willescape at pressure.NB.The fixed flow regulator should be switched on atall times to maintain a pressure up to 3bar.Ensure fixed flow regulatorThe T3 unit will automaticallyand gas are on and the T3 unitSlide the T3 unit into the Gas Tester as shown.enter the bump test foris switched on and in normalapproximately 30 secondsoperation.②Pushthe T3 unit0心into theGas TesterX02CH42until the clip①clicks'.H2S CO①Progression bar indicatesduration of testPASSFAILV02CH4H2S CoT3 unit is ready for use.A log of the test resultX02CH4has been stored in the T3 unit.H2S COTo release the T3 unit from the Gas Tester.depress the clip(①)and remove the T3unit(②)7.atee9gMap288yCALIBRATIONmessage to send the T3 unit forfailed send forcalibration.A log of the test resultcalibrationhas been stored in the T3 unit.www.crowcon.com