ThermoTekVascuTherm5使用操作说明书手册

ThermoTekVascuTherm 5 QUICK START GUIDE1 Plug the supplied power cord into2 Coolant Reservoir Fill Locationthe unit and into a grounded ACUnscrew and remove the reservoir cap and fill theoutlet.reservoir to the bottom of the reservoir neck.Closethe cap tightly.ON/OFF switchReservoir cap/fill locationPower CordconnectionTurn ON the unit.The unit will power up and present the STARTUse Caution not to overfill the Reservoir.menu.3Therapy Wrap Connections and Touch Screen Illuminated DisplayPress START®VascuTherm5To Resume TherapyCoolant portsDVT portsHelpStartNextEdema Compression port4 Start-up Steps1.Place unit upright on level surface 1-foot from any obstruction that could restrict airflow through the unit.2.Connect the supplied power cord to the unit as described in1 above.Turn on the main power switch on the side of the unit.4.Apply the prescribed therapy wraps to the indicated portions of your body as described on the wrap instructions contained in thewrap packaging.5.Unscrew and remove the reservoir cap from the top of the unit.Using the coolant bottle supplied with the therapy system,fill thereservoir to the bottom of the reservoir neck as described in above.Close the cap tightly.6.Connect the umbilical hose to the therapy wrap used for treatment.On the front of the unit,connect the clear and gray hosesfrom the umbilical hose to the fluid/compression ports.If DVT compression wraps are to be used,connect the wrap connectors tothe DVT ports of the unit.7.If the device has been pre-programmed,then by selecting "START"on the Start screen as illustrated above,the pre-programmedtherapy is initiated and the Main Therapy screen will appear.8.To stop therapy,select "STOP THERAPY"on the Main Therapy screen.Please see the User Manual for additional information,indications and contraindications for use.Doc.#OP1FMVT5QS Rev.A 2/17ThermoTek,Inc.1200 Lakeside Parkway #200,Flower Mound,TX 75028 (972)874-4949 www.thermotekusa.com