FRENIC_Ace_H_操作说明书手册

APPENDICESContentsAppendix HBefore Use…50H.1Acceptance Inspection (Nameplates for Inverter Type H)............50H.2External View and Terminal Blocks…………………52Appendix IFunction C0 des Overview-…………541.1Supplementary note……551.2Function c0 des table…………………………………………….571.3Factory default value per applicable electric motor capacitance……………841.4Mot0rC0nst归nts………………………………………………85[1 When Fuji standard motor 8-series,or other motors are selected by motor selection(Function c0deP99=00r4)……=…………85[2 When HP rating motor is selected by motor selection (Function code P99/A39=1)..86Appendix JDescription of Function codes..............87J.1 F codes (Basic functions)................................................................87[1 Frequency setting by keypad(F01 =0(Factory default state),8).............89[2 Setting up a reference frequency using analog input (F01=1 to 3,5)............90[3 Frequency setting by digital input signal "UP"/"DOWN'(F01=7)...........96[4 Frequency setting using digital inputs(option DIO interface card)(F01=11)……97[5 Frequency setting using pulse train input (F01=12).............97J.2E codes (Extension terminal functions)....................................13J.3C codes(Control functions)……176J.4PC0des(Motor1 parameters)…………………………………………185J.5 H codes (High performance functions)...............................................192[1 Measuring the capacitance of DC link bus capacitor in comparison with initial one atshipment…………………[2 Measuring the capacitance of DC link bus capacitor under ordinary operating conditionsat power shutdown……205J.6 Acodes (Motor 2 parameters)..................................................225J.7 Jcodes (Applied functions)........................226【1】PID command with the☒/keys on the keypad (J02=0,factory default)…227[2]PID command by analog inputs (J02 =1)................................................227[3 PID command with UP/DOWN control (J02 =3).................................230[4 PID command via communications link (J02 =4).....................................230[5]Pump c0 ntrol.…241J.8 d codes(Applied functions2)………293[1 Speed control (Vector control without speed or pole position sensor for PMSM)....293J.9 Ucodes (Customizable logic operation)...............297J.10U1 codes(Customizable logic operation）……322J.11yc0des(Link functions)……326Appendix KOverview of RS-485 Communication...............................................331K.1RS-485 common specifications.....................................................332K.2 Terminal specifications...................................................................333[1 RS-485 communication port 1 (for connecting the keypad).......................-333[2 RS-485 communication port 2 (terminal block).........-333K.3C0 nnection meth0d……334