EN764-5新版标准规范

EUROPEAN STANDARDEN764-5NORME EUROPEENNEEUROPAISCHE NORMOctober 2002盈1CS23.020.30English versionPressure Equipment-Part 5:Compliance and InspectionDocumentation of MaterialsEquipements sous pression-Partie 5:Documents deDruckgerate-Teil 5:Prufbescheinigungen fur metallischeconformite et de controle des materiauxWerkstoffe und Ubereinstimmung mit derWerkstoffspezifikation20.0040310This European Standard was approved by CEN on 19 August 2002.CEN members are bound to comply with the CEN/CENELEC Intemal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration.Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English,French,German).A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria,Belgium,Czech Republic,Denmark,Finland,France,Germany,Greece,Iceland,Ireland,Italy,Luxembourg.Malta,Netherlands,Norway,Portugal,Spain,Sweden,Switzerland and United Kingdom.AONanL'euEUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITE EUROPEEN DE NORMALISATIONEUROPAISCHES KOMITEE FUR NORMUNGManagement Centre:rue de Stassart,36 B-1050 Brussels2002 CEN All rights of exploitation in any form and by any meansreservedRef.No.EN764-5:2002Eworldwide for CEN national Members.