IC-751_RC-10_使用说明书手册

FREQUENCY SETTINGICOMRC-10By pushing the digit keys in order of the desired frequencydigits,the frequency display will be changed according to theFREQUENCY CONTROLLERkey that is pushed.When the frequency display shows theFOR IC-751desired trequency,push the "ENT"key and the operatingINSTRUCTION MANUALfrequency of the IC.751 will be changed to the displayed one.For ovamplaWhen desiring to set 21.234.5MHz,push the digit keys asThis instruction manual provides descriptions and operatingfollows:instructions for the optional frequency controller for ICOMtransceiver IC-751.Please read all the instructions carefully2D@☒4sENTbefore using this controller,so you will get maximum per-If you pushed a wrong digit key (before pushing the "ENT"fomance and full value from the set.key),push the"CE"key,and the frequency display showsthe provious froqueney (operating fronlianny)Nnur ynil nanFEATURESset the desired frequency again.This controller provides easy and fast frequency setting andWhen setting the desired frequency,push all digit keys inband changing by pushing key buttons.order to the desired frequency down to 1U0Hz digit,then the"ENT"key,except the desired frequency is exactly on aIn addition,this controller has a VFO switch and SPEECHMHz (for example:14.000.0MHz).3TNTHESIZER alartiiy sriLul.Which onhencs the IC 761features.For example:When desiring to set 14.000.0MHz,push the digit keys asCONNECTIONfollows;Plug in the connector attached to the end of the flat cable ofD④ENTthe controller to the board edge located at the bottom of theWhen the desired frequency is lower than 1MHz,push "010-751 as ghown in the phote.keav firet.then the digit kays nf the riasirnd ane.For example:When desiring to set 828KHz (0.828.0MHz),push thedigit keys as follows;D880ENTWhan tha IC.751 is on a HAM band and vou have entered afrequency that is out of any HAM band frequency,that fre.quency is not transferred to the IC-751 and the set workscontinuously on the previous operating frequency.OPERATIONWhen the TUNING RATE SWITCH of the IC-751 is turnedAfter connecting the flat cable to the 1C-751.set theON,the 100Hz digit will be "0",even if other figure hasnEMOTE switeh to the ON position,and tha operatinghean anterad.So if you want to set a frequency that has afrequency and VFO of the IC-751 can be controlled by this100Hz digit other than "0",turn OFF the TUNING RATEcontroller.SWITCH.Clearsa set by the digitCABLE2.REMOTE SWITCHCONNECTORthis contreller ON and OFF4.SPEECH SWITCHWhan the optional voice synthesizer unit,IC-EX310 isinstelled in the C-751,by pushing this switch,the unitis turned ON and starts to announce the displayedVFO SWITCHSwitches the VFO of the IC-751,A and BICOM INCORPORATED1-6-19.KAMIKURATSUKURI HIRANO-KU,A0521OSAKA JAPANPrinted in Jeapan