ICOM艾可慕Icom_MN-100_MN-100L_user操作说明书手册

ICOMINSTRUCTIONSThank you for purchasing this lcom product.These antenna matchers have been designed for IcomANTENNA MATCHERSHF transceivers.MN-100MN-100LPlease read all instructions carefully before installation to(for 1.5 MHz to 30 MHz)get maximum performance and full value from the trans-ceiver.■Profile■SpecificationsTo put a full size antenna on a yacht or boat is very difficult.MN-100For dipole or whip antennaHowever,these antenna matchers have been designed toMN-100LFor whip antenna onlyput an antenna in such restrictions of space,and give low·Max.input powerSSB200 W pepVSWR with short antenna elements on wide frequency rangeCW100Wof 1.5 MHz to 30 MHz.So,you can obtain the best perfor-Frequency range1.5 MHz to 30 MHzmance from the transceiver.。Input impedance50 unbalanced·Insertion lossApprox.6 dB·VSWRLess than 2.0 with supplied antennaSupplied accessorieswires·Operating temp:-30°Cto+80'C:-22Fto+176F①Antenna wiresMN-1008m“DimensionsMN-100L15m1Projections not included②Nuts4180W0×65(H)x55(D)mm③Spring washers4:732W0x26(Hx252(D)in④Flat washers4Projections included5 Mast mounting brackets2MN-100310W)×100(H×58(D)mm⑥U bolts.…7 Rubber vulcanizing tape2:1272(W)x31h6(Hx22(D)inMN-100L245W)×100(H×58(D)mm⑧InsulatorsMN-1002:9212W)x31h6(H)x2932(D)inMN-100L1Weight (approx.):MN-1001.27kg;2b13oz⑨Vire clampsMN-1004 setsMN-100L1.23 kg;2 lb 11 ozMN-100L2 sets10 Grounding wire1AConnector assembly①②®色⑩®instructions③色包面1PL-259 connector is not supplied with the MN-100/L,so④⊙▣please prepare suitable connector for the coaxial cableyou desired to use.2 Cut end of the cable evenly.Remove vinyl jacket 29 mm(11").Please do not nick the braid.3 Bare 15 mm (58)of the center conductor without nickingthe conductor.Trim braided shield 14 mm(96)and tin it.Slide the coupling ring on the cable.4Screw the plug assembly on the cable.Solder plug as-®回司⊙可@可sembly to the braid through solder hies.Solder the con-ductor to the contact sleeve.Screw the coupling ring onBthe assembly.0⊙EG5 Attach it to the connector of the MN-100/L,and cover theconnector with the supplied rubber vulcanizing tape.Icom,Icom Inc.and the Icom logo are registered trademarks of IcomIncorporated(Japan)in the United States,the United Kingdom,Ger-many,France,Spain,Russia andor other countries