22462StarSenseExplorerDX5SCT_快速操作说明书手册_R-WEBREADY

CELESTRON2StarSenseExplorer-DX5"SCHMIDT-CASSEGRAINQuick Setup GuideENGLISHITE#22462Unpack your telescope and verify that all parts areTo set up the tripod,spread the legs outward untilpresent.Your StarSense Explorer DX includes:they are fully extended and push down the centera telescope tube,a tripod and mount head,anleg brace.accessory bag,slow motion controls,an accessorytray,two eyepieces,an erect image diagonal,afinderscope,a StarSense phone dock,StarSenseExplorer Powered by SkySafariTM app code card,anda hex key (hidden inside the slot in the front of themount head).3Extend the legs of the tripod by loosening the threePlace the accessory tray on top of the center bracehand knobs on each leg.Pull each leg section alland line up the three holes.Insert the three thumbthe way out and tighten the hand knobs to securescrews through the bottom of the leg brace andthem in place.thread them into the tray.69To attach the slow-motion knobs to your mount,Place the slow-motion control knob over theHold the telescope tube next to the mount with thefirst locate the supplied hex key hidden inside theD-shaped gear shaft and push inward to make suredovetail bar on the tube facing the clamp on the topslot in the front of your mount.it is fully seated.Use the hex key to tighten theof the mount arm.setscrews onto the gear shaft.Retum the hex key toits storage position in the front of the mount.8910Slide the dovetail bar into the clamp at the top ofLocate the erect image diagonal and remove theInsert the barrel of the 25 mm eyepiece into thethe mount and tighten the hand knob on the bottomplastic covers.Insert the barrel of the diagonal intodiagonal and tighten the set screw.of the clamp to secure the telescope in place.the back of the telescope tube and secure in placeby tightening the set screws.ENGLISH1