22461_StarSense_ExplorerDX_130AZ_快速操作说明书手册_5lang_Web

CELESTRON2StarSenseExplorer-DX130AZQuick Setup GuideUnpack your telescope and verify that all parts areTo set up the tripod,spread the legs outward untilENGLISH1TE/#22461present.Your StarSense Explorer DX includes:they are fully extended and push down the center lega telescope tube,a tripod and mount head,anbrace.accessory bag,slow motion controls,an accessorytray,two eyepieces,a finderscope,a StarSensephone dock,StarSense Explorer app code cardand a hex key(hidden inside the slot in the front ofthe mount head).34Extend the legs of the tripod by loosening the threePlace the accessory tray on top of the center bracehand knobs on each leg.Pull each leg section alland line up the three holes.Insert the three thumbthe way out and tighten the hand knobs to securescrews through the top of the leg brace and threadthem in place.them into the tray.6To attach the slow-motion knobs to your mount,Place the slow-motion control knob over theTurn the clamp assembly so that the locking screw isfirst locate the supplied hex key hidden inside theD-shaped gear shaft and push inward to make sureon top of the dovetail clamp.Hold the telescope tubeslot in the front of your mount.it is fully seated.Use the hex key to tighten thenext to the mount with the dovetail bar on the tubesetscrews onto the gear shaft.Return the hex key tofacing the clamp on the top of the mount arm.its storage position in the front of the mount.8910Slide the dovetail bar into the clamp at the top of theRemove the cap from the focuser and insert the barrelSlide the finderscope bracket into the dovetail slotmount and tighten the hand knob on the bottom ofof the 25 mmeyepiece into the focuser.Tighten theon the telescope tube near the focuser.The largethe clamp to secure the telescope in place.setscrew to secure the eyepiece in place.window on the finder should be facing the front ofthe telescope.Secure the bracket by tightening thesetscrew on the dovetail slot.ENGLISH1