ET60_安装调试说明书手册-en-es-fr

丛USER MANUALWARNINGS:Risk of Electric Shock.Always checkModel ET60proper operation on a known live circuitVoltage/Continuitybefore using.TesterNever ground yourself when makingelectrical measurements.Do not use outside of rated voltages.Introduction.Do not use in wet weather.The ET60 is an AC/DCVoltage tester withCAUTION:Use extreme caution whencontinuity check,NCVchecking electrical circuits to avoid injury duedetector and a work light.to electrical shock.FLIR Systems,Inc.The attached test leads are connected withassumes basic knowledge of electricity on24"of 18-gauge wire rated at 600V.The 6"the part of the user and is not responsible fortest lead handles include spring loadedany injury or damages due to improper useprotective tip sleeves.of this tester.AC/DC VoltageAlways test on a known live circuit beforeSPECIFICATIONSuse.Non-Contact Voltage Range:90~1000To check for voltage,insert test leads intovolts ACoutlet or carefully touch test leads to theDC Voltage Range:7 LED indicators fromelectrical contacts or circuit to be tested.If6~220 voltsvoltage is present,the LED indicators willAC Voltage Range:7 LED indicators fromilluminate in the correct range.24~600 voltsUse the highest illuminated range toAC Voltage Frequency:45~66 Hzdetermine the correct voltage.If thePower:Two 1.5V AAA batteriesreadings are greater than 120VAC or 48VDC,Operating Temp.:32~122F(0~50C)the meter will vibrate.Operating Humidity:70%RH MaxUse clean,dry cloth to cleanNon-Contact Voltage(NCV)Always test on a known live circuit beforeOVERVOLTAGE CATEGORY IIIuse.Equipment of OVERVOLTAGE CATEGORY III isTo check for non-contact voltage,place theequipment in fixed installations.meter near a source of electrical energy.Note-Examples include switches in thePress the ON/OFF button to measure NCVfixed installation and some equipment forindustrial use with permanent connectionvoltage.Note that the tip of the meter offersto the fixed installation.the highest sensitivity.If voltage is present,the LED indicators will illuminate.Double Insulation:The meter isContinuityprotected by double insulation orreinforced insulation.WARNING:To avoid electric shock,nevermeasure continuity on circuits that havevoltage on them.File No.3160913Touch the test leads to the circuit undertest.The bulb at the top of the meter willCopyright 2017 FLIR Systems,Inc.illuminate if there is continuity.All rights reserved including the right of reproduction inwhole or in part in any formWorklightISO-9001 CertifiedPress the ON/OFF button to activate thewww.extech.comwork light and to measure NCV.ET60-en-es-fr_V1.0 3/17