Axe-Fx-II-Tone-Match-Manual操作说明书手册

FRACTALAUDI▣SYSTEMSAxe-Fx II Tone Match Mini ManualThe Tone Match block changes the sound of an Axe-Fx preset to match a reference signal,such as a recording or the feed from a mic on a live amp.The result can be saved rightinto the preset where it was created,or exported as a User Cab IR for use in other presets.All amp and effect settings are fully editable in presets using Tone Match.1 CreateUse your Axe-Fx II to create a starting point that is reasonably closeAMP CABTMAto the desired sound.Use the same or a similar amp type,and try toset the tone controls and drive/gain appropriately.When matching areal amp it is recommended to create a custom IR of its speaker first.Remember to include the Tone Match block,which should typicallyreplace or follow a cab.2 ConnectConnect your reference signal to the Axe-Fx II and configure the ToneMatch block to "listen"at the desired inputs.The quality,duration,and0content are all critical.You should use a high-quality recording which®isolates the tone you're trying to match without other instruments,vocals,or excess noise,or the feed from a mic/pre on a live amp.3 CaptureWhen you're ready,press the front panel "X"button to "capture"asample of the reference (press X again to stop.)Next,Tone Matchneeds to "hear"your starting preset,so play your guitar into theAxe-Fx II and press "Y"to capture this "local"signal.Advanced usersmight create test tones,or to create routings which capture bothreference and local at the same time.4 CompareWhen capturing is complete,you will see two side-by-side "frequencyplots.Press ENTER on the Axe-Fx II to create the final Tone Match.TONE9 TCHCAPTUR网四rPDTREFMCEYou'll be able to hear the result right away when you play your guitarinto the Axe-FxⅡ.5 CompleteNow fine tune and save.The Tone Match block "Process"page hasparameters to tweak,or you can adjust other blocks as desired(turnSTOREany pre-amp FX back on!)When you STORE,the Tone Match is savedright in the preset,which can be exported and shared like any other.Altemately,you can EXPORT Tone Match data into a User Cab memory.Copyright.Fractal Audio Systems.All rights reserved.Doc v1.05