Kenwood_SW-200_user操作说明书手册

KENWOODComponent parts and their functionssV-2▣▣1 TX connectorA UHF connector accepts transmitter output througha 502 coaxial cableSWR/POWER METER2 ANT connectorUHF connector for the antenna or dummy load.3 Coupler bracketUse this to affix the coupler with screws.The coupler■Featurescan be mounted on the rear of the display unit.The SW-200 through-type SWR/POWER meter which,in4 Detector cableconjunction witn a directional coupier,can be used in theCuneut tu the suupler input terminal on the dlsplay1.8-450 MHz frequency range.unit rear panel..As a through-type meter,it can be connected between5 Nameplatethe transmitter and antenna so that output can be meas-This indicates the rating of the coupler.Do not attemptured during operation.to use the coupler at power levels exceeding the specifi.Either a toroidal directional coupler (SWC-1)or a striped rating.line directional coupler (SWC-2)are used in the compan-ion detectors.Sensitivity is high,the output character.istics are flat and power can be measured without anycalibration or calculation.SWR may be measured withas little as 3W of power,in the 1.8 MHz HF band.(1)Detector2KENWOOD5wG-1MPEDANCE50520ANT.The coupler and display unit can be separated so the dis-(Figure denotes SWC-1)play unit can be mounted wherever convenient.Sinceup to 3 couplers can be connected to the display unit,one display unit can be used to observe a number oftransmitters or antenna systems..The display unit uses dual meters to simultaneouslymeasure forward and reflected power for fast and easyDownloaded bytransmitter and antenna tuning.The SW-200 SWR/POWE R meter can measure single sideRadioAmateur.EUband PEP (Peak Envelope Power).